Laboratory PRP Low Speed Digital Blood Cosmetology Centrifuge

Centrifuge Code of Practice

1. When the centrifuge is in the pre-cooling state, the centrifuge cover must be closed. After the centrifugation is finished, the rotor is removed and placed on the experimental table. The remaining water in the chamber is dried and the centrifuge cover is open.

2. The rotor cover can be placed on the platform of the centrifuge or on the experimental table during pre-cooling. Never float the rotor cover tightly, because once it is started by mistake, the rotor cover will Will fly out and cause an accident!

3. After tightening the rotor cover, be sure to touch the gap between the rotor and the cover with your fingers after tightening. If there is a gap, unscrew it and tighten it again.

4. During the centrifugation process, the operator must not leave the centrifuge room. Once an abnormal situation occurs, the operator cannot turn off the power (POWER) and press STOP. Fill in the centrifuge record before pre-cooling.

5. Do not use inferior centrifuges to make tubes, and do not use aging, deformation, cracksTextured centrifuge tubes.